• Previous message: R. Timothy Edwards: "Extraction torture test?"
• In reply to: Stefan Jones: "Re: my_printf in tclspice"
• Next in thread: Stefan Jones: "Re: Where did plot go"
• Reply: Stefan Jones: "Re: Where did plot go"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]

Well, things were going well until I downloaded magic-7.2.33.tgz and
tclspice-0.2.8 and recompiled everything. When I now load an inverter,
extract it, and either go "package require spice" or "load
/usr/lib/libspice", although I can run spice, the plot command seems to be
gone.

I did comment out the two plot statements at the end of .magic as we had
previously discussed, but now when I go:

;package require spice
;spice::source test_trans.cir
;spice::run
;plot in out


I get magic autoloading the plot module. I next tried ::plot & spice::plot
to no avail. Recompiling magic without its plot get the tcl command
spice::plot in out displaying draw, SetLinestyle 3, ... for quite a while,
but no plot appears.

I think there is a namespace thing going on here, but so far I havent
figured it out. Any suggestions would be greatly aprpeciated.

Charles Krinke

• Next message: Kevin Willis: "== Magic Development Team =="
• Previous message: R. Timothy Edwards: "Extraction torture test?"
• In reply to: Stefan Jones: "Re: my_printf in tclspice"
• Next in thread: Stefan Jones: "Re: Where did plot go"
• Reply: Stefan Jones: "Re: Where did plot go"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]